Marquis 530 Manuel du propriétaire Page 46

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 68
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 45
SOUNDSATIONS™ AUDIO-READY SYSTEM
Spa location and speaker cord routing
The factory-installed speaker cord located inside the
spa’s equipment compartment is 100 ft. long. You
must locate the spa close enough to the audio
source to allow the cord to be run so it is not exposed
to damage and does not create a trip hazard.
NOTE: A 200 ft. long speaker cord is available as an
optional replacement for the supplied 100 ft. cord.
Ask your authorized dealer for details.
Do not replace the supplied speaker cord with any
other type of cord.
WARNING! Risk of electric shock: Audio source must
be placed in a protected location at least five feet
from the spa. Do not use a portable stereo. Do not
use home audio equipment outside.
Decide on the best path for the speaker cord and
then route the speaker cord out of the equipment
compartment in the most appropriate manner for the
installation.
The speaker cord must be installed by a licensed
electrician in accordance with the National Electric
Code and all local building codes. Additional installa-
tion advise from an A/V technician may be helpful or
necessary if there are any special circumstances,
such as connecting to unique or complicated home
theater systems.
Connections
CAUTION! Risk of electric shock: The stereo cord-
connection within the equipment compartment and
the supplied 100 ft. cord which is used to conduct the
audio signal to the spa are intended to carry a low
voltage (12V) audio signal supplied by a conventional
household-type audio system. The cord-connection
and cord are not to be used for any other purpose.
CAUTION! Before making any connections, turn off
the stereo receiver and unplug it from the power
source. Failure to do so may result in damage to the
system.
1. To prepare the end of the speaker cord, strip
approximately 2" off the outer jacket.
2. To prepare the ends of the wires, strip approximately
½" of insulation from each wire. Then, twist the bare
ends of each wire so there are no loose strands of wire.
WARNING! Never use broken or frayed wire, as
damage or electrical shock may result.
2 inches (5.0cm)
Outer jacket
1/2 inch (1.3cm)
Strip approximately 2" off
the outer jacket of the
speaker cord.
spa control operation
46
Vue de la page 45
1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 67 68

Commentaires sur ces manuels

Pas de commentaire