Marquis 530 Manuel du propriétaire télécharger pdf (Page 50)

troubleshooting

PLEASE NOTE: The following corrective actions

may be performed by the spa owner. If the trouble

cannot be corrected in the steps below, please

contact your Marquis Spas

dealer for service.

(Improper servicing by an unauthorized service

provider or spa owner could result in damage not

covered by the warranty and could cause serious

injury.)

EQUIPMENT WILL NOT OPERATE

• Check the control panel LCD window for

diagnostic code.

• 240V Spas: Check the circuit breaker on the

main circuit panel.

• 120V Spas: Check the GFCI power cord and

reset if necessary (see IMPORTANT SAFETY

INSTRUCTIONS at beginning of manual).

• Check the condition of the power cord.

INADEQUATE JET ACTION

• Be sure the shut-off valves are completely open.

• Open the jets by turning the jet face to allow for

maximum water flow.

• Check for obstruction or restrictions at suction

guard(s) or filters, such as leaves, etc.

• Check to ensure water is at proper level and

add water if needed.

NO HEAT

• Check temperature displayed in the LCD

window for desired temperature setting.

• Inspect the filter cartridge for dirt and debris.

• Check that the water is at proper level, 2/3 up

the Vortex skimmer opening.

• Check HEAT MODE to be certain spa is not in

SLEEP MODE.

• Lower ambient temperatures may result in

heat loss.

NOTE: Do not expect instant hot water from the

jets. It will take the heater 12-24 hours to heat the

water to the temperature you desire.

LIGHT DOES NOT WORK

• Press the LIGHT pad on the control panel.

• Reposition the light bulb in the socket. (See

REPLACING LIGHT BULB.)

• Replace the light bulb with a 6 WATT BULB

(GE 918 ONLY).

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 67 68

Commentaires sur ces manuels

Pas de commentaire

Marquis 530 Manuel du propriétaire Page 50

Commentaires sur ces manuels